Fusion 360 Practice (Updated)
...I'll just start off by saying that I realize that this blog post is probably far too late to count for much anymore... but I'll just post what I have anyways......
Recreating the technical drawings in Fusion 360 was not too hard to do... but getting everything to constrain/relate to each other was a bit of a challenge for some of the parts.... In the end, everything worked out though...
Recreating the technical drawings in Fusion 360 was not too hard to do... but getting everything to constrain/relate to each other was a bit of a challenge for some of the parts.... In the end, everything worked out though...
Well.. that's all for this short (and very late) blog post.... tah-dah....
Comments
Post a Comment